MedLinket AM-806 Manual De Instrucciones página 20

PULSE OXIMETER is intended for use in the electromagnetic environment specified
below. The customer or the user of the Oximeter probe should assure that it is used in
such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
● Guidance & Declaration - Electromagnetic Immunity
Table 4—Guidance & Declaration — electromagnetic immunity
The PULSE OXIMETER is intended for use in the electromagnetic environment specified
below. The customer or the user of the PULSE OXIMETER should assure that It is used in
such an environment.
Immunity test
Electrostatic
discharge (ESD)
lEC 61000-4-2
Radiated RF
Electromagnetic
Fields IEC61000-4-3
Power frequency
magnetic field
IEC 61000-4-8
Table 3—Declaration electromagnetic emissions
Compliance
Group 1
Class B
IEC 60601
test level
±8 kVcontact
±2 kV,±4kV,
±8 kV,
±15 kV air
10 V/m
80MHz to2.7GHz
80% AM at 1kHz
30 A/m
50 Hz or 60 Hz
English 19
Electromagnetic environment-guidance
The PULSE OXIMETER uses RF energy for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
The PULSE OXIMETER is suitable for use in
domestic establishment and in establishment
directly connected to a low voltage power
supply network which supplies buildings used
for domestic purposes.
Compliance
level
±8kVcontact
±2 kV,±4kV±8 kV
±15 kV air
10 V/m
30 A/m
50 Hz or 60 Hz
Electromagnetic
environment-guidance
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should
be at least 30 %.
Power frequency mag-
netic fields should be at
levels characteristic of a
typical location in a
typical commercial or
hospital environment.