Charging The Battery; Inserting The Battery; Switching On / Off - Hilti SL 2-22 Manual De Instrucciones Original

5 Operation
CAUTION
Risk of damage to the eyes (the retina). Looking directly into the lamp
presents a risk of damage to the eyes (the retina).
▶ Do not direct the lamp at yourself or at anyone else.
▶ Do not, under any circumstances, look into the lamp.
Observe the safety instructions and warnings in this documentation and on
the product.

5.1 Charging the battery

1. Before charging the battery, read the operating instructions for the
charger.
2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery. → page 5

5.2 Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Turning the lamp head
▶ Turn the lamp head to the desired position.
The lamp head can be turned in either direction along the axis. Do
not attempt to force the lamp head past the end stops.

5.5 Switching on / off

1. Turn the lamp head to the desired position. → page 8
2. Select a mode by repeatedly pressing the mode switch.
▶ Brightness 100 %
▶ Brightness 50 %
▶ Off
8 English 2265887
*2265887*