Intended Use - Hilti SL 2-22 Manual De Instrucciones Original

3 Description
3.1 Product overview
LED
@
Lamp head
;
Multi-position hinge
=
Flip-up hook
%
Automatic switch
&
Mode switch (light intensity)
(

3.2 Intended use

The product described is a cordless lamp. It is intended for use as illumination
on jobsites. Use the product in a dry environment only.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22
series. For optimum performance, Hilti recommends the batteries stated
in the table at the end of these operating instructions for this product.
• For these batteries, use only Hilti chargers of the type series stated in
the table at the end of these operating instructions.
3.3 Items supplied
Cordless lamp, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group
3.4 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and
the battery's state of health.
3.4.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product,
subsequently check that the battery is correctly re-engaged and secure.
Short-press the release button of the battery to get whichever of the following
status indications is applicable at the time.
State of charge and, if applicable, faults are indicated constantly as long as
the connected product is switched on.
Status
Four (4) LEDs show constantly
green
*2265887*
1
)
+
§
/
:
Meaning
State of charge: 100 % to 71 %
2265887
Grip
Installation opening for acces-
sories
Battery
Battery release button
Battery status indicator
English 5