Hilti SPN 6-22 Manual De Instrucciones Original página 19

8.4 Checking die, punch guide and wear plate 11,
Option: SPN­RN
OR SPN­RL
CAUTION
Risk of damage to product and cutting tools!
▶ Clean the threads before installing the securing screws.
▶ Always use the new securing screws supplied and tighten the screws to the specified tightening torque.
1. Remove the securing screws.
2. Remove the punch guide and the die.
3. Check the wear plate for signs of wear.
Result
If clear signs of wear are visible:
▶ Remove the wear plate and install a new replacement.
4. Clean the contact surfaces of the die bearing.
5. Use the pins to center the punch guide and the die.
6. Reinstall the securing screws and tighten until hand-tight.
7. Grease the guide surfaces of the punch guide.
8. Tighten the securing screws to the specified torque in diagonally opposite sequence.
Technical data
Tightening torque
9 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
*2331867*
12
2331867
3 Nm
(2 ftlb )
f
English 13