Westward 22XP38 Instrucciones De Operación Y Manual De Piezas página 11

All manuals and user guides at all-guides.com
Westward Operating Instructions and Parts Manual
5. If the cable becomes lodged in the drain, use sharp downward thrust while the cable is
turning. Then try again when the cable is not turning.
6. If the lodging is caused by a bend and you have difficulty getting the cable to pass the
bend, you probably need a thinner cable. Try to use a 3/8" diameter cable or even a
smaller one if necessary.
Hint: It's often helpful to have a small stream of water running in the line to wash the
debris away while the machine is in operation.
7. After the line is opened, retrieve the cable from the drain line and push it back into the
drum while the Rotation Switch (See figure in Page 5) is set in the FOR position. This is
important to prevent the cable from tangling in the drum or in the line.
Do not set the Rotation Switch in REV when pulling the cable out of the
drain line. Always run the machine in FOR rotation, whether you are feeding the cable
into the line or pulling it out.
When the cutting tool is near the drain opening, take your foot off the
Foot Switch to stop drum rotation. Never retract the cutting tool from drain while cable
is rotating. The cable could whip and cause serious injury.
22XP38, 22XP39
Drain Cleaning Machine
11