Assembly And Disassembly - Westward 22XP38 Instrucciones De Operación Y Manual De Piezas

All manuals and user guides at all-guides.com
Westward Operating Instructions and Parts Manual
Assembly and Disassembly
Turn Rotation Switch to OFF and unplug before
assembly and disassembly.
Quick Assembly
Handle Mounting
The handle is bound to the frame but is not mounted. To assemble the Handle, take off the two
sets of handle‐locking bolts and knobs from the frame. Slide the two ends of the handle into the
two openings on the frame. Then, use handle‐locking blots and handle‐locking knobs to tighten
them.
Toolbox Mounting to the Handle
The tool box can be attached to the machine by simply aligning the two
slots on the box with the two poking latches on the frame and sliding
the tool box downward to allow the two latches to slip into the slots.
Wheel Mounting
To assemble the wheels, push the axle through the holes at the bottom
of the frame, mount the wheels on the Axle and then use one flat
washer and one nut on each side to attain the wheel on the axle.
Cable Feeder (Optional) Installation
To install the Cable Feeder, follow these steps:
1. Push the cable through the Cable Feeder's opening.
2. Place the mounting bracket at the bottom of the Cable Feeder unit on the
frame. Be sure to align the holes for the mounting screws.
3. Tighten the mounting bolts and nuts.
Cable Guide (Optional) Installation
To install the Cable Guide
1. Pull the lock pin on the adapter of the cable guide and slide the
adapter end of the Cable Guide onto the front of the Cable Feeder.
2. Make sure to align the lock pin with the hole on the short tube of
the Cable Feeder.
3. Release the lock pin to let it slide into the hole and hold the cable
guide on the Cable Feeder.
22XP38, 22XP39
Drain Cleaning Machine
7