ItsImagical BEETLE YELLOW Manual Del Usuario página 11

All manuals and user guides at all-guides.com
3. Charger
4. Rear mirror
5. Wind screen
6. Seat
7. Front wheel
8. Rear wheel
9. Φ10 washer
13
15
10. Flat washer
11. Pin
12. Wheel cover
10
13. Body
12
14. Battery
10
15. Remote controller
12
14
ASSEMBLY INSTRUCTIONS
1. Assemble the front wheel: )Fig 1(
Insert the large washer and the front wheel into the front axle and then insert
the small washer, then lock the snap-pin into the hole, finally cover with the
trim to complete the wheel assembly. Repeat for the other front wheel.
2. Assemble the rear wheels: )Fig 2, 3(
Insert the rear wheels into the rear wheel axle )the side with the protrude
toward inner(. Please note that the protrude must engage with the gear box.
Insert the small washer. Then lock then lock the snap-pin into the hole, finally
cover with the trim to complete the wheel assembly.
3. Assemble the windscreen: )Fig 4(
Align the windscreen with two side slots between the dashboard and the body,
and push it into place, pushing both sides at the same time. )Please note that
the two sides of the windscreen must be stressed evenly(.Push the middle of
the windscreen until you hear a click to complete the assembly.
4. Assemble the steering wheel: )Fig 5(
Insert the steering wheel into the steering pole, ensuring that you align the hole
of the steering wheel with the hole of the pole. If necessary, lift the steering
wheel slightly to align the hole with hole of the pole and fit it with the screw. Do
not damage the buttons on the steering wheel during assembly.
5. Assemble the wing mirrors: )Fig 6(
Insert the wing mirror into the slot of the body, push it into the slot until you
hear the click to complete the assembly. Please note to differentiate between
the left and right mirrors.
6. Assemble the battery: )Fig 7(
First undo the connector of the battery as shown. Remove the battery from the
battery packing box and place it into the slot. Assemble the strip and hold in
place with the screw. Lastly connect the battery connector with the connector
of the body.
7. Assemble the seat: )Fig 8(
Place the seat over the battery compartment, and turn the two screws on the
seat to lock the position.
8. Assemble the remote controller battery
Buy 2* 1.5V AAA battery, open the battery cover with the screwdriver. Put the
two battery into the battery cavity with the correct polarity, and put the battery
cover lastly. If the red bulb does not work, pls change the battery based on the
above procedure.