ItsImagical BEETLE YELLOW Manual Del Usuario página 12

All manuals and user guides at all-guides.com
OPERATING INSTRUCTION
1. Forward and reverse )Fig10, 11(
Driver sits in the car well, turns the power switch to ON and Manual/Remote
control switch to Manual, then set the forward/reverse shifter to the desired
direction and press on the foot pedal to apply power to the vehicle and front
lights, removes foot from foot pedal will stop the vehicle and front lights went
out.
2. Remote operation:
See picture 11, turn on "Power" switch, and press to "Remote" button, there
are four speed showed on remote control,"1" is the lowest speed, and "4 " is
the fastest. From 1 to 4, speed becomes faster. Set down the optional speed,
turn remote control on "Forward", car goes forward, turn "Reverse", car backs
up. Car stops when not press button, "Left/Right" button on remote control
can turn cars left and right. And the remote will turn off automatically after 5
seconds with no operation.
3. Steering wheel function )Fig 12(
The steering wheel has the start and speed up sound.
4. Battery recharge
When battery is low please recharge. To charge please remove the seat and
unplug the battery connection then insert the charger connection and plug
into an electric supply. Make sure the car is stopped and turned off during
charging.
5. Power indication:
The 2.4 GHZ remote controller have function of showing car battery power
condition. When the toy car in power-on & remote control status, press forward
or reverse button, the power indicator will lighting, green means battery power
is filled; blue signifies power is in normal condition; red stand for battery
power is low, you have to stop operating and charge the battery immediately.
Otherwise, the battery will be damaged.
6. One to one coding function for remote control, see picture, remote control
need to match code with car when first use, turn on remote control power,
there light will twinkle, press the small switch in back side of remote control,
meanwhile turn on the switch on PCB board under car seat, by that time, the
flashing light will stop twinkling, then this remote and car are matched. If want
to over the matching relation, re-press the switch on remote control.
7. Stop function )Fig16(
No matter manual operation or remote operation, if have any emergency,
press the STOP button, the car will stop and lights of the speed indicator cycle
flash at the same time. (The remote controller hibernates automatically in 15
minutes, and the light will extinguish automatically.( After pressing the STOP
button, the car can not drive. Only after the unlock, it can have the function.
There are two ways for the unlock. 1, Press any button of forward, reverse,
turning, it is unlocked. 2. Turn off the power switch in 15 minutes, and then turn
on the switch.