Charging The Battery Pack; General Information On The Operation - Kärcher WD 3 Battery Manual Del Usuario

18 Floor nozzle
(with insert)
19 Battery pack
Battery Power 36/25
20 Standard charger
Battery Power BC 36 V
Assembly
Illustration
 To open, pull the container closures upwards and
remove the device head on the carrying handle.
Illustration
 Remove the contents from the container.
Illustration
 Turn the container, press in the steering roller in the
openings at the base of the container till the end-
point.
Illustration
 Put the appliance head onto the container and lock
the container locks.
Illustration
 For vacuuming dry dirt an additional filter bag can
be inserted if necessary.

Charging the battery pack

Illustration
Illustration
Note: Please observe the operating instructions for the
battery pack.
Commissioning
ATTENTION
Vacuuming without a cartridge filter
Device damage
Always ensure that the cartridge filter is inserted, for
both wet vacuuming and dry vacuuming.
Inserting the filter bag
Illustration
 Push the suction hose into the connection on the
appliance, it snaps in place.
 Attach the filter bag to the device connection and
press it on firmly.
 Fit and lock the device head.
Note: We recommend using a filter bag to vacuum fine
dust.
Accessory application
Illustration
 Connect the suction hose.
Illustration
 Connect the suction hose to the handle.
 Put both suction tubes together and connect them
with the handle.
Illustration
Note: For convenient vacuuming in confined spaces,
the handle can be removed and the accessory attached
directly to the suction hose. To release the handle,
press the grey tabs on either side of the handle and pull
the handle off the hose.
Illustration
 Install the floor nozzle.
 Install the insert in the floor nozzle.
Connect the floor nozzle to the suction pipes.

Inserting the battery pack
Illustration
 Push the battery pack from the top into the battery
holder and lock it.
ATTENTION
Damage to the device
Only use battery packs from the KÄRCHER Battery
Power (+) platform with 36 V nominal voltage.
Turning on the Appliance
Illustration
 Position I: Vacuum and blowing function.
Position 0: Appliance is switched off

General information on the operation

ATTENTION
The metal container can become statically charged
when vacuuming large amounts of fine dust particles
and then discharge upon contact.
ATTENTION
The batter holder area must be kept clean.
 If there is too much dirt in this area, it is possible
that the battery pack is not inserted/locked into
place.
 Similarly, it may be the case that battery pack can
no longer be taken out of the device because the
eject lever can no longer be moved.
Dry vacuum cleaning
ATTENTION
Before use, check the cartridge filter for damage and re-
place if necessary.
Work with a dry cartridge filter only!
Illustration
 Recommendation: To vacuum fine dust, use the
filter bag.
Note: Replace the filter bag in good time, as a filter bag
that is too full could be damaged. The fill degree of the
filter bag depends on the amount of dirt vacuumed. The
filter bag should be replaced more frequently when vac-
uuming fine dust, sand, etc.
ATTENTION
Vacuuming cold ashes
Device damage
Only vacuum cold ash with a preliminary filter.
Wet vacuum cleaning
ATTENTION
Wet vacuuming with a filter bag
Device damage
Do not use a filter bag for wet vacuum cleaning!
ATTENTION
Operation with a full container
When the container is full, a float switch closes the suc-
tion opening and the device runs at a higher speed.
Switch off the device immediately and empty the con-
tainer.
Note:If the device falls over, the float can also close. To
make the device capable of vacuuming again, set up the
device, switch it off, wait 5 seconds and then switch it on
again.
– 7
EN
Operation
11