Safety Instructions; Alarm Functions - ASCOM 9d24 MkII Guía De Referencia Rápida

phonebook will be searched and a list of matching names will
be displayed. You can step to the next entry in alphabetic
order by pressing the Navigation key. Press "Select" or Call
key to make the call.
Soft keys and Hot keys
The three Soft keys below the display can be defined for spe-
cific functions such as dialing a specific number etc.
A Hot key can have the same function as a Soft key and any
key "0" - "9" can be programmed as a Hot key.
For more information about Soft keys and Hot keys; see User
Manual, 9d24 MkII Cordless Telephone.
Turn the automatic keypad lock on/off
Enter "Settings" , step to "General" and press
"Auto key lock, press "Change"; the Auto lock checkbox is
marked/unmarked. A locked keypad is indicated by the
"Locked keypad" icon.
Switch the telephone off/on
Off: Enter "Modes"
"Select".
Step to "Yes" and press "Ok".
On: press and hold the Call key
will be displayed. Press "Yes" within 10 seconds.

Alarm functions

Personal alarm*
Press the red Alarm button twice within 2 seconds. "Personal
alarm" is displayed.
Test alarm*
Press and hold the red Alarm button until "Test alarm" is dis-
played.
*Dependent of installation
Deactivate/Activate Alarms
Enter "Settings" , step to "Alarm settings" and press
Select "No-movement", "Man-down", or "Pull-cord", press
"Change"; the checkbox is unmarked/marked.
Hot keys/Soft keys can also be reserved for deactivation/
activation of alarms.
10
All manuals and user guides at all-guides.com
. Select
. Step to "Switch off" and press
; the question "Switch on?"
P P r r o o t t e e c c t t o o r r v v e e r r s s i i o o n n s s o o n n l l y y

Safety instructions

This product shall only be used with the following batteries:
P/N:660087 Battery
P/N:660088 Battery Medic
P/N:660121 Battery EX-version
Desktop chargers shall only be connected with power adap-
ters supplied by the manufacturer.
Available power adapters are:
P/N: FW7650/05
ATEX/IECEx Safety Instructions
Charge the battery
When charging an EX-version the desktop charger must be
marked with DC2 and the charging rack must be marked with
CR2.
In combination with EX-version, use approved battery types
only. The battery must be marked with ATEX on the label.
Battery charging or replacement is NOT permitted in hazar-
dous area.
For approved battery types, see EC Type Examination and
IECEX Scheme Certificate of Conformity and following supp-
plements.
The document above and the EC Declaration of Conformity
can be found at http://www.ascom.com/ws/solutions_ws/
products_ws.htm and http://www.iecex.com.
Remove the battery
The battery is fastened by a screw that requires a special tool,
Battery pack opener for ATEX. To remove the battery, use the
opener and turn the screw to horizontal position. Remove
the battery by pulling the screw. When fastening the battery
again the screw has to be in horizontal position. To fasten
the battery use the opener and turn the screw to a vertical
.
position.
Removing the battery is NOT permitted in hazardous area.
Power supply unit AC/5V DC/1A.
GB
11