VWR PCR Guia De Inicio Rapido página 5

Slide the connection assembly into the cavity
of the back panel
Assemble the back panel  onto the base .
The connecting link of the base  must fit in
the back panel . Pay attention not to
squeeze the sensor cable.
Connect both parts by screwing 3 screws  into the back side. Use the screw driver  to do this. Turn
the parts around 90° on the site of operation and incline both screwed parts to the back part of the back
panel . Screw both panels with 2 screws  from underneath. Tilt back the panels in starting position
with the back panel facing backwards.