Craftmade CL52 Instrucciones De Instalación página 4

Insert wires from top of support rod through hole "A" (See Inset 1) in
bottom of Support Arm Distributor. Insert end of remaining rod into
hole "B" and in bottom of distributor. Place wires through hex nuts and
tighten nut securely onto support rods. Use hex nuts to secure remaining
two rods into place. Insert wires through hole "C" and pull through top
of downrod section of distributor.
C
Hex Nut
Support Arm
Distributor
CAUTION:
Do not mount fan to sheet rock or drywall type materials. To insure proper support use
the two #1 wood screws to secure mounting bracket to joist or beam, if the location
you have chosen does not have a suitable support beam, install a 2" x 4" brace between
ceiling joists to support fan, or one of the many NEC and UL approved ceiling fan
braces.
WARNING:
To reduce the risk of fire, electric shock or personal injury, mount to outlet box
marked "acceptable for fan support" and use mounting screws provided with
the outlet box. Most outlet boxes commonly used for the support of lighting
fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
All manuals and user guides at all-guides.com
Down Rod
Hex Nut
Inset 1
A
B
Locate downrod assembly (#2).
Loosen ball screw on black
hanging ball to free lock pin.
Black hanging ball will slide
down. Remove ground screw and
green ground wire. Remove
hanging ball from downrod and
save all parts. Insert wires and
steel cable from distributor
assembly through downrod. Screw
downrod into top of Support Arm
Distributor Assembly (#8), being
careful that wires are pulled
through.
Position downrod so the hole in the downrod aligns with the hole in the
distributor assembly. At this point you can turn the Fan Support Arms in
the direction you want. Insert safety bolt (S10) through distributor
assembly and downrod and attach nut. Tighten firmly. Tighten set screw
"A" against downrod. Place distributor cover (#8a) over support arm
distributor (#8). Next place canopy (#3) over downrod assembly (#2).
Replace hanging ball, insert hanging pin through downrod and tighten set
screw "C" in hanging ball into downrod.
Threaded Set
Screw Hole
Ground
Hanging
Wire
Pin
Ball
Screw
Hanging
Ball
Safety Bolt
and Nut
WARNING:
Failure to completely
tighten downrod as
described in steps 7 & 8
above could result in the fan
loosening and possibly
falling.
Lock Pin
Green Ground
Wire
Ball Screw
Downrod
Assembly
Hanging Ball
(#2)
Downrod
Support Arm
Distributor
Assembly (#8)
Set Screw (C)
Downrod (2)
Canopy (3)
Distributor
Cover (8a)
Set Screw (A)
Distributor
Assembly (2)
Support
Arms