Hilti SSH 6-22 Manual De Instrucciones Original página 14

4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.2 Blade
Blades of different types are needed, depending on the thickness or strength of the material to be cut. Select
the correct blade for the purpose from the table below.
The blades have two cutting edges. The cutting edges cannot be resharpened.
Initial equipment, as supplied ex works: SSH­CS 1.5 ­ 2.5 mm or SSH­CD4 mm × 0.9 mm
SSH­CS,
0.5 ­ 1.5 mm,
, for
straight cuts
Permissible steel 1.5 mm
thickness, steel (0.06 in) 16 ga
up to 400 N⁄mm²
Permissible steel 1.0 mm
thickness, steel (0.04 in) 20 ga
up to 600 N⁄mm²
Permissible ma- 2.0 mm
terial thickness, (0.08 in) 12 ga
aluminum up to
250 N⁄mm²
Permissible •/•
material
thickness, steel
spiral ducting up
to 400 N⁄mm²
Permissible •/•
material
thickness, steel
spiral ducting up
to 600 N⁄mm²
Starting hole di- 17 mm
ameter
(0.7 in)
Smallest radius 80 mm
for curved cut-
(3.1 in)
outs
8 English
SSH­CS, SSH­CX,
1.5 ­ 2.5 mm, 0.5 ­ 1.5 mm,
, for , for
straight cuts straight cuts
in stainless
steel
2.5 mm •/•
(0.10 in) 13 ga
•/• 1.5 mm
(0.06 in) 16 ga
3.0 mm •/•
(0.12 in) 9 ga
•/• •/•
•/• •/•
22 mm 20 mm
(0.9 in) (0.8 in)
150 mm 120 mm
(5.9 in) (4.7 in)
21.6 V
See the end of these operating
instructions
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 40 ℃
(−4 ℉ ... 104 ℉)
−10 ℃ ... 45 ℃
(14 ℉ ... 113 ℉)
SSH­CC, SSH­CD,
0.5 ­ 1.5 mm, 4 x 0.9 mm,
, for curves
ducting
1.5 mm •/•
(0.06 in) 16 ga
0.8 mm •/•
(0.03 in) 22 ga
2.0 mm •/•
(0.08 in) 12 ga
•/• 4 x 0.9 mm
(4 x 0.035 in)
4 x 20 ga
•/• 4 x 0.6 mm
(4 x 0.024 in)
4 x 24 ga
15 mm 18 mm
(0.6 in) (0.7 in)
L 45 mm (2 in), 150 mm
R 80 mm
(5.9 in)
(3.15 in)
2331869
*2331869*
, for spiral