Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
Risk of damage to product and cutting tools!
▶ Clean the threads before installing the securing screws.
▶ Always use the new securing screws supplied and tighten the screws to the specified tightening torque.
1. Remove the securing screw and remove the cut-off plate.
2. Clean the thread.
3. Insert the new cut-off plate and install the new securing screw.
Technical data
Tightening torque
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Switching on
1. Press the rear section of the on/off switch.
2. Slide the on/off switch forward.
▶ The motor runs.
3. Lock the on/off switch.
6.2
Cutting
5
Before starting work, check that the cutting rails and the cut-off plate are correctly and securing seated
and check the tightening torques of the corresponding securing screws.
1. Switch the tool on. → page 11
2. Guide the product through the material to be cut while holding the product at an angle of about 14 ° to
the material.
Always use a sharp blade and turn or change the cutting rails in good time.
Apply cutting oil or other cooling lubricant to the workpiece to prolong the useful life of the cutting
tools.
3. If the following conditions are met, also take this action:
Conditions: Cutting curves
▶ Guide the product slowly through the material, following the applicable radius.
Do not tilt the product to the side.
4. To end the cut, switch the product off.
6.3
Cutting off swarf
Do not cut off short lengths of swarf. The minimum length of the strip of swarf cut off must be one
complete curl.
Marks on the front of the housing indicate the cut-off position.
1. With the product switched on, press the swarf cutter for 0.5 of a second.
▶ The strip of swarf is cut off at the mark and the cut-off process stops automatically.
2. Remove the cutting of swarf by hand.
6.4
Switching off
▶ Press the rear section of the on/off switch.
▶ The on/off switch jumps into the off position and the motor stops.
*2331869*
6
2331869
5 Nm
(4 ftlb
)
f
English
11
Publicidad
Tabla de contenido
