X10 LK15 Manual De Usuario página 4

All manuals and user guides at all-guides.com
sends your commands safely around the existing house
wiring to Lamp or Appliance Modules. Lamps & appliances
plugged into these modules, anywhere in the house, will
instantly respond to the commands you transmitted. There is
no need for any installation work, just plug in the Home
Automation Modules as you would do with any other
electrical equipment.
Changing the House Code and Unit Code
If necessary, you can change the standard House Code (A...P;
NOTE: this code needs to be the same for ALL the modules)
and Unit Code (numerical code of a module that
corresponds with a number assigned to your remote
control).
To change the House Code on the Radio
Transceiver TM13:
Set the dial on the front of the Radio Transceiver to a new
code, for instance to B. The Unit Code of the Radio
Transceiver is fixed to number 1.
To change the House Code of the KR22 Key Chain
Remote:
1. Press and hold the top On button. The red light starts
flashing and 3 seconds later blinks the current setting:
1 blink is House Code A, 2 blinks is House Code B, etc..
2. Release the top On button (you have now entered the
remote's programming mode).
3. Set the required new House Code by pressing the top On
button (once for A, twice for B, etc.). IMPORTANT: Hold
the button on your last press and 3 seconds later the red
light will blink the new setting.
4. Release the On button.
To change the Unit Code of the KR22 Key Chain
Remote:
To program a new Unit Code, you will only have to program
the keys. The other buttons will then automatically be one
4
LK15