X10 LK15 Manual De Usuario página 5

All manuals and user guides at all-guides.com
Unit Code higher than the first one. For instance when you
give the top buttons (button 1) Unit Code number 6, the
next buttons (2) automatically get Unit Code 7.
1. Press and hold the top Off button. The red light will start
flashing and 3 seconds later blinks the current setting:
1 blink is Unit Code 1, 2 blinks is Unit Code 2, etc..
2. Release the top Off button (you now entered the
remote's programming mode).
3. Set the required new Unit Code by pressing the top Off
button: once for 1, twice for 2, etc.. IMPORTANT: Hold
the button on your last press and 3 seconds later the red
light will blink the new setting.
4. Release the Off button.
To change the House Code and/or Unit Code of the
LM15 Lamp Socket:
1. Set the remote control to the required House and Unit
Code as described above.
2. Turn the power off and wait a few seconds.
3. Turn the power back on again.
4. You now can give a new code for the Lamp Socket within
30 seconds. To do so press the button (On) left of the
number of your choice on the remote control 3 times.
When for instance you want the LM15 to react to button
number 4, push the button left of number 4 on the
remote control 3 times.
5. From now on the LM15 will react to the buttons left (On)
and right (Off) of the number 4.
For changing the batteries of the Key Chain Remote KR22E,
remove the back lid of the remote (for instance by using
your finger nails in the groove on the side). Exchange the
batteries for the same type (2 x CR2016, 3V lithium). Please
take care in observing the polarity.
5