Touchpad; Pc Card/Pcmcia - EUROCOM Milano M360 Guia Del Usuario Concisa

TouchPad (WinXP)
1. Double-click TouchPad from the Driver Installation
.
menu (go to step 3)
OR
Click Start (menu) > Run
2. If your computer is Model A:
Navigate (Browse...) to
D:\Drivers\Touchpad\Synaptics\Win2K_XP\Setup.e
xe and click OK.
If your computer is Model B:
Navigate (Browse...) to
D:\Drivers\Touchpad\KTP3\WinXP\Setup.exe and
click OK.
3. Click Next > Next > Next.
4. Click Finish to restart your computer.
All manuals and user guides at all-guides.com
... .
(go to step 2)
PC Card/PCMCIA (WinXP)
The instructions for installing your PC Card driver will
depend on your PCMCIA module type.
1. Click Start (menu), point to Settings and click Control
Panel (or just click Start > Control Panel).
2. Double-click System (icon); System (icon) is in
Performance and Maintenance (category).
3. Click Hardware (tab) > Device Manager (button).
4. Click "+" next to PCMCIA adapters (if its sub-items
are not shown).
5. If you see Texas Instruments PCI-1410 CardBus
Controller DO NOT install the driver as it is not
required.
OR
If you see Generic CardBus Controller then follow
these steps:
6. Double-click ENE_PCMCIA from the Driver
.
Installation menu
OR
Click Start (menu) > Run
to D:\Drivers\ENE-PCMCIA\Setup.exe and click
OK.
7. Click Next > Next.
8. Click Finish to restart your computer.
Concise User's Guide
...
and navigate (Browse...)
Driver Installation - 29