Inductive Mode - RIDGID SeekTech ST-510 Instrucciones De Funcionamiento

SeekTech
Tools For The Professional
TM
Inductive Clamp Method
Figure 16: Inductive Clamp (Optional)
1. Plug the inductive clamp into the 1/4" phone jack
above the battery cover. Plug must be mono or, if
stereo, connected between tip and base. The coil
cords are disabled when the clamp is connected.
2. Clamp the jaws of the Inductive Clamp around a
section of the pipe or cable to be traced.
3. Power the transmitter on and proceed as in the
Direct Connect method. Be sure the receiver and the
transmitter are set to the same frequency.
0
ST-510
®
Ridge Tool Company

Inductive Mode

The ST-510 can be used without a direct connection to a
pipe or cable. In Inductive Mode, the ST-510 generates a
field which induces a current into a conductor such as a pipe
running directly beneath it.
1. Be sure that the transmitter is positioned correctly
over the line.
Figure 17: Orientation to the Conductor
2. Push the inductive mode (upper right) button to
induce a signal onto the line. The Inductive Mode
message will appear on the screen.
Orientation Mark
(Inductive Mode)