Parts And Components; Before Use; Product Assembly - cecotec READYWARM 7000 TOUCH Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1.
1. Power switch
2. Handle
3. LCD display
4. Oil-filled fins
5. Casters
6. Cord storage
LCD display
Fig. 2.
1. Display
2. On/off
3. Power level/ ºC-ºF
4. Temperature/time increase
5. Temperature/time decrease
6. Timer
7. Wi-Fi (only for Connected models)

2. BEFORE USE

Remove all packaging elements.
Check all parts of the appliance for visual damage. Unwind the power cord completely and
inspect it for damage. If there are any signs, contact the official Technical Support Service of Cecotec.
Make sure you have read and understood all instructions and warnings in this instruction
manual. Pay particular attention to the safety instructions on previous pages.
Place the appliance on an even, heat-resistant surface.

3. PRODUCT ASSEMBLY

Turn the heater upside down.
Place the casters base assemblies between the end fins.
Attach them to the heater using the U-bolts and wing nuts supplied.
Tighten the wing nuts.
Turn the heater the right way up.
Fig. 3.
32 READYWARM 7000/9000/11000 TOUCH AND TOUCH CONNECTED
4. OPERATION
Note: This device has a safety switch which turns the electricity off as soon as the device falls
over. The safety switch prevents dangerous situations caused by overheating.
Switch the power switch to 0.
Connect the device to a properly installed earthed socket.
Switch the device on from the side switch. The device will beep, and all the LED indicators and
the screen will light up on for 1 second.
The device will automatically enter standby mode and the power LED indicator will be
displayed on the screen.
Fig. 4.
Press the power button on the screen, the device will beep and the heater will enter high
heating power level (P3). The device will show the room temperature. Press the power button
again to switch to standby mode.
Heating power levels
During operation, press the mode button to select ºC or ºF.
Hold down the mode button to enter heating settings. The display will show P3. Press
repeatedly to select P3->P2->P1.
P3: High heating power level
P2: Medium heating power level
P1: Low heating power level
While the device is heating, press the "+" and "-" buttons to set the desired temperature, from
10 ºC to 35 ºC.
Thermostat
When room temperature reaches the set temperature, the heater will automatically turn
off. When the room temperature is lower than the set temperature, the heater will turn
automatically on again. After 5 seconds, the system will automatically exit the setting mode
and the display will show the room temperature.
Timer
While the device is heating, press the timer button to enter the timer settings. The display will
show "OH".
Press the "+" and "-" buttons to set the desired operating time, from 1 to 9 hours.
After 5 seconds, the system will automatically enter countdown, and the screen will display
the room temperature.
When the countdown gets to 0 and the set operating time is over, the device will
automatically enter standby mode.
READYWARM 7000/9000/11000 TOUCH AND TOUCH CONNECTED
ENGLISH
33