Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
With all connections completed reconnect the negative battery terminal.
1.
2. Plug the LC-GMRC-LAN03 harness into the LC-GMRC-LAN03 interface and then to the wiring
harness in the vehicle.
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. To initialize the interface, turn the ignition on and wait for (30) seconds.
2. Cycle the ignition off, then back on.
3. Test all functions of the aftermarket radio installation fo r proper operation, including proper
balance and fader operation.
4. Close all the doors then turn the key off. The radio should stay on until the driver's door
is re-opened.
Note: If the radio doesn't come on within (60) seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
TESTING
REV. 1/17/22 INSTLC-GMRC-LAN03
3
Publicidad
