Technical Data; Noise And Vibration - Ferm HDM1014 Traducción Del Manual Original

As the colours of the wires in the mains cable of
the unit may not correspond to the coloured
markings identifying the terminals in the plug,
proceed as follows:
connected to the terminal which is marked with
the letter N or coloured black.
connected to the terminal which is marked with
the letter L or coloured red.

TECHNICAL DATA

NOISE AND VIBRATION

Sound pressure (L
pa
Acoustic power (L
wa
Sound pressure (L
pa
Acoustic power (L
wa
2
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in EN
another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
patterns
HDM1014
Your hammer drill has been designed for drilling
holes into wood, steel, and masonry. The
machine can also be used as a demolition
HDM1014
ASSEMBLY
4
2
2
1.5
2
2
2 1.5
Mounting
Removing
different or poorly maintainted accessories,
it is running but not actually doing the job, may
4. Chuck
5. Locking sleeve
Before assembly, always switch off the
machine and remove the mains plug
Immediately sharpen or replace blunt
accessory.
counterclockwise until it locks into place.