Possible Problems And Solutions - Alecto BL-329 Modo De Empleo

Possible problems and solutions:

All manuals and user guides at all-guides.com
First always check whether the power adapter is plugged
in a 230 AC wallsocket or the 12 V DC plug is connected
with the cigar-lighter in your car.
Problem:
The red LED on the
power adapter does
not light.
The yellow LED
does not light in the
"refresh"-mode.
The "discharge/
charge" LED does not
light in the charge-
mode.
Possible cause:
No power on the wall-
socket.
The switch is not set in
the correct position.
Bad electrical contact.
The batteries are
installed incorrectly.
Bad electrical contact.
The batteries are
installed incorrectly.
The switch is not set in
the correct position.
35
Solution:
Check the mains
power by connecting
another device with
the wall socket.
The switch should
be set in the middle
position.
Clean the charger's
contacts as well as
the contacts of the
batteries.
Re-install the
batteries in the
correct way.
Clean the charger's
contacts as well as
the contacts of the
batteries.
Re-install the
batteries in the
correct way.
The switch should be
set in the left position
(2 batteries) or in
the right position (4
batteries)