Behringer XENYX UFX1604 Guia De Inicio Rapido página 13

24 XENYX UFX1604
XENYX UFX1604 Getting started
Step 3: Getting
(EN) Make sure the power to all devices is
turned off .
started
Connect all appropriate power, audio and
FireWire/USB cables to the mixer.
Set all faders to the down position,
PAN/BAL knobs centered and all other
knobs (except EQ) all the way left.
Turn the mixer on.
With the MAIN MIX fader, PHONES,
CONTROL RM, and ALT 3-4 knobs all the
way down, turn your PA system or
powered monitors on.
Slowly raise the MAIN MIX fader,
PHONES, CONTROL RM and ALT 3-4
knobs to 0 or the desired level.
Adjust the level of connected
microphones and instruments by raising
each CHANNEL FADER.
25 Quick Start Guide
Adjust the left-right position of a channel
in the stereo fi eld if necessary by turning
the channel's PAN or BAL knob.
the MAIN MIX fader. If the CLIP LEDs on the VU
METER light, lower the MAIN MIX fader.
Adjust the COMP knob to add
compression to an input if necessary.
For live applications, adjust the overall Use the channel AUX knobs and master
output from the mixer to the power AUX SEND knobs to send the channel
amp or powered speakers by raising signals to an eff ects processor or stage
monitor connected to the AUX SEND jacks. If used
for eff ects, route the signal back from the processor
to the AUX RETURN jacks.
VIRTUALIZER 3D FX2000
EUROLIVE F1320D
active floor monitor