Behringer XENYX UFX1604 Guia De Inicio Rapido página 14

26 XENYX UFX1604
Gain Setting
Step 4: Gain Setting
(EN) Press the Channel 1 SOLO button.
Press the MODE button under the
VU METER in the main section to allow
the METER to operate in PFL (pre-fader listen) mode.
Sing, Speak or play at a normal level
through the microphone or instrument
connected to Channel 1.
While singing or playing, turn Channel 1's
GAIN knob. The VU METER will display the
signal level. Set the GAIN so the loudest
peaks reach 0 on the VU METER. Press the Channel 1
SOLO button again.
Repeat steps 1-3 for any other channels
that will be used.
27 Quick Start Guide
Dual Multi-FX Processors
Step 5:
(EN) Your mixer has two built-in eff ects processors.
Follow these steps to add one or two eff ects to one
Dual Multi-FX
or more channels.
Processors
Turn the FX A or FX B knob up halfway
on each channel you would like to add
an eff ect to.
Turn the FX SEND and FX RETURN knobs
to "0". You may adjust them later.
Make sure the FX ON button is
pushed in.
Scroll through the eff ects by turning
the FX A knob (same for FX B).
Adjust the intensity of the eff ect by
turning the EDIT knob.
If using presets 1-8, 13-14 or 16,
press the TAP/SELECT button to toggle
between two diff erent values
(light off /on) for the second parameter.
To adjust the delay time of presets 9 and 15, hit the
TAP/SELECT button several times in the tempo
of the music piece. Similarly, hit the TAP/SELECT
button several times to adjust the modulation
speed of presets 10-12. The button will start
fl ashing in the corresponding tempo.
Readjust each channel's FX knobs to
make sure the right amount of FX A
or FX B is added.