Braun Oral-B Professional Care D 17 511 Manual página 6

English
All manuals and user guides at all-guides.com
The Oral-B Professional Care has Professional timer
been developed together with With a signal you can
leading dental professionals to hear and feel, the timer
effectively remove plaque from all invites you to brush
areas of your teeth. quadrant by quadrant.
It adds a gentle pulsating action After every 30 seconds,
to its oscillation to create a deep- it signals by a very short stutter that
cleaning 3D brushing action. it is time to move to the next
It has been designed for daily use quadrant. After two minutes – which
for the whole family. is the recommended brushing time –
the timer signals by a longer stutter.
Please read the use instructions
carefully before first use. Pressure Sensor
For safety and optimum brushing
Important results, the toothbrush has
Periodically check the cord for any a pressure control system:
damage. Should this be the case, If too much pressure is applied,
take the charging unit (e) to a Braun the oscillating movement of the
Service Centre. A damaged or non- brushhead will continue, but the
functioning unit should no longer pulsation will stop. In addition to
be used. feeling it, you can also hear the
difference.
Description
During the first few days of using
®
a INDICATOR brushhead the toothbrush, your gums may
b Switch bleed slightly. In general, bleeding
c Handle should stop after a few days.
d Charge indicator Should it persist after 2 weeks,
e Charging unit please consult your dentist or
f Roll-stop hygienist.
g Wall holder
INDICATOR
Specifications The INDICATOR
Power supply: monitor and improve your brushing
see bottom of charging unit performance. With proper brushing,
Handle voltage: 1.2 V twice a day for two minutes, the blue
colour on the INDICATOR
will disappear half-way down within
Connecting and charging
3-4 months, signaling it is time to
The toothbrush is electrically safe change the brushhead (B).
and can be used in the bathroom
without hesitation. Replacement brushheads
Available at your dealer or Braun
• Plug the charging unit into an Service Centres.
electrical outlet. Place the handle
on the charging unit.
Cleaning
•
The charge indicator (d) flashes
while the handle is being charged. •
• When the handle is fully charged,
the charge indicator lights
permanently. A full charge takes
at least 16 hours and provides an
operation time of approximately •
45 minutes.
• For everyday use, the handle
can be stored on the plugged-in
charging unit to maintain the
toothbrush at full power.
Overcharging is impossible.
Battery maintenance
•
To maintain the maximum capacity
of the rechargeable battery, unplug
the charging unit and discharge
the handle by regular use at least
Environmental notice
every 6 months.
This product is provided with a
nickel-hydride battery which does
Using the toothbrush
not contain any harmful heavy
This product can be used with metals. Nevertheless, in the interest
any leading brand of toothpaste. of protecting the environment,
please do not dispose of the prod-
To avoid splashing, guide the uct in the household waste at the
brushhead to your teeth before end of its useful life. Disposal can
switching the appliance on. take place at a Braun Service
Centre.
Operating the switch
The toothbrush features two However, if you prefer to dispose
speed options, the lower speed of the battery yourself, please refer
being optimal for sensitive areas to the chapter «Battery removal»
in the mouth (A). on page 17.
• Press the switch to operate with
normal speed, Subject to change without notice.
•
press a second time to operate
with reduced speed,
• press a third time to switch the This product conforms to the
unit off. EMC-Directive 89/336/EEC
and to the Low Voltage
Removing plaque Regulation 73/23 EEC.
Guide the brushhead slowly from
tooth to tooth. Hold the brushhead
in place for a few seconds before
moving on to the next tooth.
Brush the gums as well as the teeth,
first the outsides, then the insides,
finally the chewing surfaces. Do not
press too hard or scrub, simply let
the brush do all the work.
5
®
bristles
®
bristles help you
®
bristles
Rinse the brushhead thoroughly
under running water for several
seconds with the handle
switched on (C).
Switch off the appliance and
remove the brushhead from
the handle. Clean both parts
separately under running water,
then wipe them dry before you
reassemble the brush and put
the handle on the charging
unit (D).
From time to time, also clean the
charging unit with a damp cloth.