DJ-Tech SL1300 MK6 USB-SIL Manual De Instrucciones página 6

OPERATIONS
1. Push Power button to on.
2. Insert target light for illumination the stylus.
3. Place a record on the turntable mat. When playing a
45rpm record with a large center hole; place the
45-rpm adapter on the center spindle.
4. Set the rotation speed to match the record.
5. Release the arm clamp.
6. Set the cueing lever to the up position.
7. Press the Start/Stop button and the turntable platter
will start to rotate.
8. Move the tone arm over the desired groove.
9. Set the cueing lever to the down position, the tone
arm will descend slowly onto.
The record and play begins.
SET-UP
Headshell and Cartridge Assembly
When installing a cartridge (not included), refer to the operating instructions of that cartridge. During installation,
attach the stylus protector to guard the stylus tip from damage.
Connect the Headshell lead wires to the cartridge terminals. The terminals of cartridges and the Headshell lead
wires are color coded. Connect each lead wire to the cartridge terminals of the same color.
White (L+) ................................Left channel +
Blue (L-) ...................................Left channel -
Red (R+) ..................................Right channel +
Green (R-) ...............................Right channel -
Turntable Assembly
A. Headshell : Insert the Headshell into the front end of the Tonearm Assembly. While holding Headshell firmly into
the front end of the tonearm assembly, turn the Headshell Locking Nut counter-clockwise to firmly secure the
Headshell to Tonearm Assembly.
B. Counterweight : Locate and remove the tonearm Counterweight from the packaging. Slide Counterweight onto
the rear of the Tonearm. Turn it lightly and it will screw onto the rear shaft of the tonearm.
All manuals and user guides at all-guides.com
10. Set the desired pitch adjusts range by depressing
11. Adjust the pitch to a desirable speed, move the
12. To suspend play, lift tone arm with cueing lever.
13. When play is finished, raise the cueing lever, move
14. Press the Start/Stop button to stop the platter
15. Push the Power button to off.
6
the buttons until the desired pitch is reached.
Options are +/-10%, +/-20% or +/-50%.
pitch control slider up or down to adjust the
speed.
the tone arm to the arm-rest and secure the tone
arm with the arm clamp.
rotating.
Note: Compatible Cartridge includes:
Audio Technica AT3600L or equivalent