Moving The Wet/Dry Vac; Blowing Feature - RIDGID VAC11000 Manual Del Usuario

SP6948 VAC1100 ESF.qxp_SP6948 6/4/15 8:54 AM Page 11
Operation (continued)
1. The Vac comes equipped with a drain
for easy emptying of liquids. Simply
unscrew the drain cap and lift the
opposite side slightly to empty the drum.
2. Another option is to remove the drum
from the Vac.
3. Pull the drum out from the Vac by
pulling down and sliding the drum on
the axle support under the drum.
4. Dump the drum contents into the
proper waste disposal container.
5. Replace the drum by reinserting into
the cavity and push until it snaps into
place.
Dust
Drum
Axle
Support
Drain

Moving the Wet/Dry Vac

To maneuver the Vac, the metal handle in
the rear of the unit should be positioned
in the upright position for ease of
movement. Be sure to unlock the back
wheels by pulling up on the wheel locks
before moving the Vac.
All manuals and user guides at all-guides.com
TC AR T
SM AR
Pull Down and
Slide Dust Drum
Out of Wet/Dry
Vac Unit
Pull Up to Unlock
Wheel Locks
11

Blowing Feature

Your Vac features a blowing port. It can
blow sawdust and other debris. Follow
the steps below to use your Vac as a
blower.
1. Locate blowing port of your Vac.
2. Insert the locking end of the hose
assembly into the blowing port of the
Vac. The hose should snap into place.
To remove the hose from the Vac,
press the release button in the hose
assembly and pull the hose out of the
Vac inlet.
3. (Optional) Attach extension handle to
opposite end of hose, then place the
crevice tool on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Locking End
Hose
Assembly
Blowing Port