Setting The Maximum Limit Of Power; Maintenance And Cleaning; Use - baraldi Nice 60 Manual

INSTRUCTIONS FOR USE
2.7 Setting the maximum limit of power
The maximum power of the hob can be set at different levels: 7200W, 6000W,
3500W, 2800W, 2200W, 1600W or 1000W. The factory setting is 7200W; if it is
reduced, the hob limits the setting of the hot plates or when they are switched
on to the maximum power set. If this limit is exceeded, the "
Procedure - limitation up to 2800W:
Within 30 seconds of connecting the hob to the mains or whenever power is
restored, with the keypad lock deactivated, touch the symbols of the front
left cooking and back right cooking areas simultaneously for about 2
seconds, the displays will show the power setting selected; by touching the "
" and " " symbols, the maximum power can be increased or reduced.
Confirm the setting by touching the symbols of the front left and back right areas
simultaneously within 60 seconds.
Procedure - limitation up to 1000W:
Within 30 seconds of connecting the hob to the mains or whenever power is
restored, with the keypad lock deactivated, touch the symbols of the front
left cooking and front right cooking areas simultaneously for about 2
seconds, the displays will show the power setting selected; by touching the "
" and " " symbols, the maximum power can be increased or reduced.
Confirm the setting by touching the symbols of the front left and back right areas
simultaneously within 60 seconds.
3.1

Maintenance and cleaning

Before each operation, disconnect the appliance from the mains.
After each use, when cool, clean the hob eliminating even the small residues
which, when the hob is switched on again, can become impossible to remove.
Only use suitable products, avoiding steel wool pads, abrasive sponges and
powder detergents as these products can scratch the surface of the glass.
Sprays to clean ovens are not suitable as they are aggressive and damaging for
the surface of the glass.
Slight residue can be removed with a damp cloth or with hot soapy water.
Ring marks from soap can be removed with water which must be dried using
32 / GB

USE

" symbol appears.