Electrical Requirement; Cleaning Before Use; Space Requirements - Candy CFL 3650/1 E Manual Del Usuario

using(except the rating label).
To remove any remaining tape or glue, rub the area briskly with your
thumb.
Tape or glue residue can also be easily removed by rubbing a small
amount of liquid dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your refrigerator.
When moving the refrigerator, do not tilt the refrigerator beyond 45 °
from upright position.

CLEANING BEFORE USE

After you remove all of the packaging materials, （especially the foam
between outside condenser and cabinet should be removed）clean
the inside of your refrigerator before using it.

SPACE REQUIREMENTS

WARNING: Keep flammable materials and vapors, such as
gasoline, away form refrigerator.
Failure to do so can result in death, explosion, fine or burns.
To ensure proper ventilation for your refrigerator, allow for 200mm
space on each side between walls, 100mm space between back of
your refrigerator and the wall, and 300mm space between counter top
and the roof or ceiling.
All manuals and user guides at all-guides.com
2
If you are installing your refrigerator next to a fixed wall, leave
sufficient space on the hinge side to allow for the door to swing open.
Never install your refrigerator near heat source and direct sun shins.

ELECTRICAL REQUIREMENT

WARNING: DO NOT REMOVE GROUND PRONG
DO NOT USE AN ADAPTOR
DO NOT USE EXTENSION CORD
Failure to follow these instructions can result in death, fire or electrical
shock.
Before you move your refrigerator into its final location, it is important to make
sure you have the proper electrical connection.
Caution: risk of fire!
Due to use flammable refrigerant (R600a) and/or the flammable insulation
blowing gas used, this gas is natural gas with high environmental
compatibility that is, however, also combustible. When transporting and
installing the appliance, care should be taken to ensure that no parts of the
refrigerating circuit are damaged.
Refrigerant and/or insulation blowing gas squirting/leaking out of the pipes or
body of appliance could ignite or cause an eye injury. If leak is detected,
avoid any naked flames or potential sources of ignition and air the room in
which the appliance is standing for several minutes.
3