Cameo FLASH BAR 150 Manual De Usuario página 14

Tabla de contenido

Publicidad

OPERATION / BEDIENUNG / UTILISATION / OPERACIÓN / OBSŁUGA / UTILIZZO
EN
After the spot has been correctly connected to the mains and switched on, it is ready for use and starts with the mode that was previously se-
lected.
SELECTING THE DMX START ADDRESS
Press the MODE button repeatedly until the currently set DMX address appears on the display (A001 - A512). Using the UP and DOWN buttons, the
DMX start address can now be set as desired. Confirm the input with ENTER. The synchronous control of multiple spotlights (same model) through a
DMX control unit (e.g. DMX console) can be achieved by assigning the spotlights to an identical DMX start address and DMX mode and connecting
them using DMX cables.
UP/DOWN
SETTING THE DMX MODE
Press the MODE button repeatedly until one of the 6 available DMX modes is displayed (CH01, CH02, CH03, CH05, CH15, CH20). The DMX mode can
be adjusted as desired by using the UP and DOWN buttons. Confirm the input with ENTER. You will find tables with the channels of the different DMX
modes in this manual under DMX CONTROL.
UP/DOWN
AUTOMATIC CONTROL
Select one of the 5 different Auto programs (SH01 - SH05) and adjust their speed (SP01 - SP10). Press the MODE button repeatedly until of the auto
programs appears on the display, select the desired program using the UP and DOWN buttons and confirm by pressing ENTER. Press the MODE button
once to access the menu item for setting the program speed. One of the 10 speed levels will be shown on the display and you can use the UP and
DOWN buttons to select the desired speed as required (SP01 - SP10). Confirm the input with ENTER.
UP/DOWN
SLAVE MODE
Press the MODE button repeatedly until "SLoF" or "SLon" appears on the display. Now use the UP and DOWN buttons to select "SLoF" for "Slave
operation disabled" or "SLon" for "Slave mode enabled" and press ENTER to confirm. When the slave mode is enabled, connect the slave and the
master unit (same model) using a DMX cable and activate one of the standalone modes on the master unit. Now the slave unit follows the master unit.
UP/DOWN
ROTATE THE DISPLAY BY 180 
Press the MODE button repeatedly until "rdoF" or "rdon" appears on the display. Now use the UP and DOWN buttons to select "rdoF" for "Display
rotation disabled" or "rdon" for "Display rotation enabled" and press ENTER to confirm.
UP/DOWN
MUSIC CONTROL
Select the Music control mode to control the spot via the built-in microphone (bass pulses). Press the MODE button repeatedly until "SnoF" or "Snon"
appears on the display. Now use the UP and DOWN buttons to select the menu item "SnoF" for "Music control disabled" or "Snon" for "Music control
enabled" and press ENTER to confirm. Press the MODE button once to access the menu item for adjusting the microphone sensitivity. The currently
set value will be shown on the display and you can use the UP and DOWN buttons to select the sensitivity with which the spotlight reacts to sound, as
required (SE01 = minimum sensitivity, SE99 = maximum sensitivity). Confirm with ENTER.
UP/DOWN
14
-> ENTER
-> ENTER
-> ENTER
-> MODE
UP/DOWN
-> ENTER
-> ENTER
-> ENTER
-> MODE
UP/DOWN
-> ENTER
-> ENTER

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Clfb150

Tabla de contenido