Agri-Fab 45-04561 Manual Del Usuario página 7

20. Secure the top and bottom hopper tubes together
using two 5/16" x 3/4" hex bolts (17) on inside and
21
17
21. Install two cotter pins (27) in the rear hopper tube.
Bend ends of cotter pins around tube.
22. Slide the dump handle clip (33) onto the dump handle.
23. Attach the dump tube to the rear hopper tube using a
U-­clamp (34) placed between the cotter pins, a 1/4"
x 1-­1/2" hex bolt (16) and a 1/4" nylock nut (24). See
24. Swivel the dump tube so that the end of the tube
rests on the ground behind the bag and supports the
rear of the bag in an upright position.
33
All manuals and user guides at all-guides.com
17
21
FIGURE 13
24
27
5
FIGURE 14
25. Insert the hopper support rods (7) into the hole
beneath the curved head bolt (26) in each upper
hopper tube. Flex and insert the rod into the hole in
NOTE:
7
26.
27. Hammer a palnut (23) onto each end of the pivot rod .
HINT: Place the bag on its side on a hard surface to
make installation of palnuts easier.
34
16
7
26
7
7
FIGURE 15
2
23
FIGURE 16