Intended Use; Qualification Of Personnel - KS Tools efuturo Instrucciones De Uso

OPERATING INSTRUCTIONS
efuturo Wallbox

Intended use

The device is intended exclusively intended for use as described in the „Product description" chapter with the supplied
and approved components.
Any use beyond this is considered not in accordance with the intended use. KS Tools GmbH is not liable for any damage
resulting from this. The risk for this is borne solely by the owner/user.
The following points also form part of the intended use:
• Observance of all instructions in this manual
• Compliance with the maintenance work
The device can be dangerous if it is not employed in accordance with its intended use.

Qualification of personnel

The electrical installation, start-up and maintenance of the device are only allowed to be carried out by a qualified
electrician. The specialist must have read and understood this installation manual.
Requirements for a qualified electrician:
• Observance of the general and special safety and accident prevention regulations
• Observance (e.g. DIN VDE 0100 part 600, DIN VDE 0100-722) as well as the applicable national regulations
• Ability to identify and assess risks and hazards in order to prevent hazards
Instructions for persons with a pacemaker or implanted defibrillator
Charging systems from KS Tools that are operated as intended comply with the European Directive on Electromagnetic
Compatibility with regard to interference radiation.
If persons with a pacemaker or defibrillator wish to carry out activities on charging systems and their equipment in
normal operation, KS Tools cannot make any statement regarding the suitability of such medical devices. KS Tools
GmbH is not in a position to assess the corresponding pacemakers or defibrillators with regard to their susceptibility to
electromagnetic radiation. Only the manufacturer of the pacemaker or defibrillator can do this. KS Tools GmbH therefore
recommends that affected persons should not work on our charging systems until they have consulted the manufacturer
of the pacemaker or defibrillator and the responsible insurer. In any case, make sure in advance that there are never any
health or safety risks.
Persons with a pacemaker or defibrillator must not work on or be present at charging systems and their equipment, e.g.
for maintenance purposes or for troubleshooting.
Sending back devices
If you send the device back to KS Tools GmbH for repair, use the original packaging or a suitable secure transport
container..
Warranty
If you have any complaints about the device, contact KS Tools GmbH immediately, stating:
• Type designation AND serial number
• Reason for the complaint
• Time in service
• Ambient conditions (temperature, humidity, installation location)
5