Connection Terminals - KS Tools efuturo Instrucciones De Uso

Caja de pared
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65

Connection terminals

RCD type B
RCD Typ B
N
L
1~ 230V/50Hz
Connect the feeder cable:
1. Remove the cable insulation from the feeder cable over a length of 150 mm. Remove the wire insulation and press
on suitable wire end sleeves.
2. Connect the wires of the feeder cable according to the circuit diagram. The protective conductor (PE) must be longer
than the remaining conductors!
3. Check that the individual wires are connected correctly and that the screws are tightened properly.
Start-up
!
Warning
Danger due to faulty start-up!
There is an increased risk of injury to persons carrying out work for which they have neither been qualified nor
instructed.
• The device is only allowed to be installed by persons who are familiar with it, have been informed about the
dangers and possess the necessary qualifications
• All safety conditions must be fulfilled before installation
There are five configuration switches under the cover of the controller. The configuration switches are used to set the
charging current limit.
OPERATING INSTRUCTIONS
efuturo Wallbox
L
N
P1 P2
RD
V0
GN
BL
PE
Status-
Status
controller
Q1
controller
V0
CP CS
3~ 400V/50Hz
Steck-
Socket
Dose
DIP
L
N
P1 P2
RD
V0
Status-
controller
RCD Typ B
V0
CP CS
N
L2
L3
L1
DIP
DIP
GN
BL
PE
Q1
Steck-
Dose
DIP
DIP
15

Publicidad

Tabla de contenido
loading

Tabla de contenido