Adjusting The Shape Of The Picture (Geometry); Adjusting The Convergence (Convergence) - Sun Microsystems GDM-5510 Manual De Instrucciones

Adjusting the shape of the picture
(GEOMETRY) Y)
The GEOMETRY settings allow you to adjust the rotation and
shape of the picture.
The (rotation) setting is stored in memory for all input signals.
All other settings are stored in memory for the current input
signal.
1
Press the MENU button.
The menu appears on the screen.
2
Move the control button up or down to highlight
GEOMETRY and press the control button.
The GEOMETRY menu appears on the screen.
3
Move the control button up or down to select the
desired adjustment item. Then press the control
button.
The adjustment bar appears on the screen.
4
Move the control button up or down to make the
adjustment. Then press the control button.
Select To
rotate the picture
expand or contract the picture sides
shift the picture sides to the left or right
adjust the picture width at the top of the screen
shift the picture to the left or right at the top of the
screen
0
reset all the GEOMETRY adjustments to the
RESET
factory setting levels. Select OK.
For more information about using the RESET mode, see
"Resetting the adjustments (RESET)" on page 14.
Adjusting the convergence
(CONVERGENCE)
The CONVERGENCE settings allow you to adjust the quality of
the picture by controlling the convergence. The convergence
refers to the alignment of the red, green, and blue color signals.
If you see red or blue shadows around letters or lines, adjust the
convergence.
These settings are stored in memory for all input signals.
1
Press the MENU button.
The menu appears on the screen.
2
Move the control button up or down to highlight
CONVERGENCE and press the control button.
The CONVERGENCE menu appears on the screen.
3
Move the control button up or down to select the
desired adjustment item. Then press the control
button.
The adjustment bar appears on the screen.
4
Move the control button up or down to make the
adjustment. Then press the control button.
Select To
horizontally shift red or blue shadows
vertically shift red or blue shadows
vertically shift red or blue shadows at the top of
T
the screen
TOP
vertically shift red or blue shadows at the bottom
B
of the screen
BOTTOM
0
reset all the CONVERGENCE adjustments to
RESET
the factory setting levels. Select OK.
For more information about using the RESET mode, see
"Resetting the adjustments (RESET)" on page 14.
10
EN