Before Starting The Equipment; Operation; Practical Tips - EINHELL TP-DH 50 Manual De Instrucciones Original

Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vi-
brations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
5.1 Additional handle (Fig. 2)
For safety reasons you must only use the demoli-
tion hammer with the additional handle.
The additional handle (3) enables you to achieve
better stability while using the demolition hammer.
The additional handle (3) can be turned to any
required position:
•
To do this, undo the fastening for the additio-
nal handle (4).
•
Now turn or tilt the additional handle (3) into
the most comfortable working position for you
and then tighten the fastening (4) again.
5.2 Inserting the tool (Fig. 3-4)
Before inserting it, clean the tool and lightly grea-
se the shaft of the tool.
1. Pull out the locking bolt (5) as far as possible
and hold it.
2. Turn it through 180° and release it. It does not
matter which direction you turn it in.
3. Guide the tool with the flat side facing the bolt
into the tool chuck (6) and slide it in as far as
Anl_SA_TP_DH_50_SPK8.indb 25 Anl_SA_TP_DH_50_SPK8.indb 25
GB
it will go.
4. Pull out the locking bolt (5) again and hold it.
5. Turn it through 180° again and release it. It
does not matter which direction you turn it in.
Check the lock by pulling on the tool.
5.3 Removing the tool
To remove the tool, follow the steps in reverse.

6. Operation

Important.
To avoid danger, the machine must only be
held using the two handles (1/3). Otherwise
you may suffer an electric shock if you chisel into
cables.
6.1 ON/OFF switch (Fig. 5)
Switching on:
Move the ON/OFF switch (2) to the position „I".
Switching off :
Move the ON/OFF switch (2) to the position „O".

6.2 Practical tips

6.2.1 Sharpening chisel tools
You will only achieve good results if you use sharp
chisels. You should therefore sharpen the chisels
promptly to ensure that they produce good results
and provide a long service life.
- 25 -
22.11.2021 07:24:37 22.11.2021 07:24:37