Allen-Bradley PanelView Plus Serie Instrucciones De Instalación página 13

The terminals using 24V dc power are EN 61131-2 Equipment Class II devices.
Use a Class 2/SELV (Safety Extra-Low Voltage), isolated and
ATTENTION
ungrounded power supply as input power to the terminals.
This power source provides protection so that under nominal
!
and single fault conditions, the voltage between conductors
and between conductors and Functional Earth/Protective Earth
does not exceed a safe value.
To connect DC power:
1. Secure the DC power wires to the terminal block screws.
2. Secure the Functional Earth (FE) ground wire to the
screw.
3. Apply 24V dc power to the terminal.
Logic Module with
DC Power Input
Functional Earth Ground
All manuals and user guides at all-guides.com
PanelView Plus/VersaView CE Terminals and Display Modules
+ DC Positive
-
DC Negative
terminal block
Publication 2711P-IN001B-MU-P
13