Wiring And Safety Guidelines - Allen-Bradley PanelView Plus Serie Instrucciones De Instalación

If the modules are ordered separately, attach the Logic Module and Communication
Module) to the Display Module before panel installation. See instructions shipped
with each module.
The VersaView CE terminal is shipped with RAM and Compact Flash pre-installed in
Logic Module. The RAM and Compact Flash are not pre-installed in the Logic
Module of the PanelView Plus. You must install the memory before attaching the
Logic Module to Display Module. See instructions shipped with Logic Module.

Wiring and Safety Guidelines

Use publication NFPA 70E, Electrical Safety Requirements for Employee Workplaces
when wiring the terminals. In addition to the NFPA guidelines:
• connect the terminal and other similar electronic equipment to its own
branch circuit
• protect the input power by a fuse or circuit breaker rated at no more than 15
Amps.
• route incoming power to the terminal by a separate path from the
communication lines.
• where power and communication lines must cross, they should cross at right
angles. Communication lines can be installed in the same conduit as low
level DC I/O lines (less than 10 volts).
• grounding minimizes noise from Electromagnetic Interference (EMI) and is a
safety measure in electrical installations. To avoid EMI, shield and ground
cables appropriately.
A source for grounding recommendations is the National Electrical Code published
by the National Fire Protection Association of Boston.
All manuals and user guides at all-guides.com
PanelView Plus/VersaView CE Terminals and Display Modules
Publication 2711P-IN001B-MU-P
5