Harbor Breeze CHA52BNK5LR Manual página 13

FINAL INSTALLATION
2.
DANGER: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades (J). If screws are overtightened, blades (J)
may crack and break.
Partially insert three blade screws (AA) along with
three fiber blade washers (BB) into holes in blade (J)
to attach blade arm (L) to blade (J). Then, tighten
each blade screw (CC) starting with the one in the
middle. Repeat with remaining blades (J).
Hardware Used
Blade Screw
AA
Fiber Blade Washer
BB
3.
Locate motor screws/washers (R) that were
previously removed (Step 6, page 7).
Insert two motor screws/washers (R) through one
blade arm (L) to attach blade arm (L) to motor
housing (D). Tighten motor screws/washers (R)
securely. Repeat with remaining blade arms (L),
making sure to completely secure each blade
arm (L) before proceeding with the next.
4. Partially loosen two motor plate screws (K) in motor
plate on underside of motor housing (D) and
remove the other motor plate screw (K). Align
slotted holes in fitter plate (H) with loosened motor
plate screws (K), allowing molex connections from
motor housing (D) to come through hole in fitter
plate (H). Twist fitter plate (H) to lock. Re-insert the
motor plate screw (K) that was removed and
securely tighten all three motor plate screws (K).
2
x 15
x 15
3
4
Motor
Plate
Molex
Connections
13
AA
BB
L
D
H
R
I K
I K
I K
J
D
I H