Operating Instructions - Harbor Breeze CHA52BNK5LR Manual

FINAL INSTALLATION
8.
Align slots on shade (M) with protrusions on
underside of fitter plate (K). Turn shade (M)
clockwise until it no longer turns.
NOTE: Pull down gently on the shade (M) to make
sure it is secured completely.
9. If you wish to use the remote control bracket from
remote pack (O), install screws from remote pack
(O) through bracket and into the desired installation
site. The remote control transmitter from remote
pack (O) rests inside the bracket.

OPERATING INSTRUCTIONS

CAUTION: The remote control transmitter can be programmed to multiple receivers or fans.
If this is not desired, turn wall switch off to any other programmable receiver or fan.
1. Remove battery cover from back of remote
control transmitter in remote pack (Q). Install
battery from remote pack (Q) with positive (+)
end toward top of remote control transmitter.
Replace battery cover on remote control
transmitter.
WARNING: Choking Hazard - Small parts.
Keep battery away from children.
NOTE: Battery is NOT rechargeable. Remove
battery with low or no charge and dispose of
properly.
8
H
9
1
Battery
Cover
15
M
Wall
Bracket
Screws
Remote Control
Bracket
Remote
Control
Transmitter
(back
side)
Battery
Protrusion
Slot
Q