Craftmade Cole Guia De Instalacion página 8

9. Light Kit Assembly. (cont.)
Remove 1 screw and partially loosen the other 2
screws from underside of fitter plate.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLUE (or
BLACK) wire from motor housing to BLUE wire
from LED light kit. Be sure molex connections snap
together securely.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws
in fitter plate. Twist LED light kit to lock. Re-insert
screw that was previously removed and tighten all
3 screws with a Phillips screwdriver.
If you wish to USE the light kit, align grooves on
shade with nodules on inside of fitter plate and
push up gently on shade. Twist shade to the RIGHT
(clockwise) until shade locks into place. Pull down
VERY GENTLY on shade to make sure that shade is
secure.
If you do NOT wish to use the light kit,
on metal cover and align with nodules inside fitter
plate. Gently push up on metal cover and turn to
the RIGHT (clockwise)
WARNING: Metal cover will be HOT if light is left
on.
locate slots
until it no longer turns.
LED
light kit
fitter plate
shade
fitter plate
metal cover
page 8
motor
housing
molex
connections
motor
housing
grooves
motor
housing
grooves
fitter plate
nodules
nodules