NuWave OXYPURE ZERO Manual Del Propietário página 20

CLEANING & MAINTENANCE
Filter Maintenance Indicator
The FILTER 2 and FILTER 4 lights will turn green in about 3 months to
alert you that the Bio-Guard
optimal performance (NuWave Recommendation). When either light turns
red (after about 6 months), that Bio-Guard
cleaned, press and hold down TIMER for 2 seconds until a beep is heard
to reset the Clean Filter 2 Indicator. To reset the Clean Filter 4 light, hold
the TURBO button for 2 seconds until a beep is heard. Once the Clean
Filter lights are reset, they will go out.
Cleaning the Dust Sensor
The Dust Sensor is located on the side of the unit.
1. Open the Dust Sensor Cover.
2. Using a dry cotton swab or small, soft brush, gently remove any dirt or
dust from the Sensor.
3. For more buildup on the Sensor, wipe it with a slightly wet cotton swab.
4. Remove any moisture with a dry cotton swab.
5. The Sensor requires regular cleaning (approx. every 3 months) for the
unit to operate efficiently.
6. If the OxyPure
frequent cleaning of the Sensor is needed.
7. Do not use the cotton swab on any part or area other than the Sensor.
Do not immerse the OxyPure in water. Clean the outside of the unit with
a damp sponge or cloth and wipe it dry. Make sure all parts and covers
are securely attached. Do not dry the filters with a hot blow dryer.
Changing and Cleaning the Filters
The filters need to be cleaned on schedule to help the unit maintain
optimum performance.
1. Remove the Filter Access Panel in the rear of the OxyPure
built-in handle.
2. Carefully slide out the filters that need cleaning. Do not shake them.
3. Immerse the Stainless-Steel prefilter and Bio-Guard
DO NOT get the Ozone Emission Removal Filter wet.
4. Clean the filters as directed. DO NOT use paper towels.
5. Always allow the washable filters to dry completely, out of direct sunlight,
before you reinstall them. Never place a wet filter into the OxyPure.
6. Reattach and close the Filter Access Panel. If the panel is not properly
closed, the POWER button will blink red and the unit will not power on.
20
cleaning & maintenance
filters SHOULD be cleaned to maintain
®
is set up in an area with high dust accumulation, more
®
filter MUST be cleaned. Once
®
filters in water.
®
using its
®