Publicidad
1.6 STANDBY MODE
During measurement of the "STANDBY MODE" condition, the main converter is off (PS_ON=High).
+5Vsb converter is working and standby input power is measured.
Load Condition
<45mA
45mA
100mA
250mA
1.0A
1.7 ACTIVE POWER FACTOR CORRECTION (PFC)
PFC at half/full load:
>0.95 at AC 110v 60Hz(typical)
>0.90 at AC 230v 50Hz(typical)
2.0 OUTPUT
GROUP
VOLTAGE
MAX.LOAD
MIN.LOAD
REGULATION
LOAD REGULATION
RIPPLE & NOISE (mV)
Capacitive Loads_(uF)
NOTE:
1.The continuous maximum total output power shall not exceed 700W.
+12V DC maximum output power shall not exceed 58A(696W).
+3.3V and +5V DC maximum combined output power shall not exceed 100W.
2.Maximum peak total DC output power should not exceed 770W.
3.Peak power and current loading should be supported for a minimum of 1 second.
4.+3.3V, +5V and +12V DC output voltage should be within Figure 1 cross loading range to meet regulation.
5.Ripple and Noise measuring with an oscilloscope with 20 MHz bandwidth in Figure 1 cross loading range.
Output should be bypassed at the connector with a 0.1uF ceramic disk capacitor and a 10uF electrolytic
capacitor to simulate system load. The length of ground wire on probe should not longer than 40mm,
if a Non – differential type of scope was used.
Efficiiiency
>=50%
>=55%
>=65%
>=75%
*2013 ErP Standby efficiency
+3.3V
20A
0A
±2%
0.5%±
0.5%±
30
10000
10000
----
1
+5V
+12V
20A
58A
0A
0A
±2%
±2%
0.5%±
35
40
20000
Power in
<0.45W
----
----
----
2
-12V
+5VSB
0.3A
2.5A
0A
0A
±10%
±5%
60
35
330
10000
02
Publicidad
