Riding; Engine Start - Husqvarna CR 125 2012 Guía Rápida

RIDING

ENGINE START

For the correct start of a cold engine proceed as follows:
- shift the transmission into neutral;
CR:
- open cock (1), by loosening ring nut (2);
WR:
- set fuel valve (3) in ON position;
- lift the knob lever (4) on the carburetor .
Leaving the throttle in closed position operate kick-start
(5) .
Take the knob lever in its initial position as soon as the
engine is idling .
When starting with an already warmed up engine DO
NOT USE the starter . You can start the engine with the
gear inserted, after disconnecting of the clutch .
If the carburetor is flooded, shut off the fuel supply and
the starter and operate the crank lever or the kick-start
until the engine starts . If necessary, remove the spark
plug and dry it .
N
EN - 10
QUICK MANUAL
8000H7113-CR-WR125_MY2012_ed0_06-2011.indd 10
All manuals and user guides at all-guides.com
IMPORTANT NOTE IN CASE OF COLD STARTS
AT LOW TEMPERATURES
It is recommended to briefly warm-up
the engine at idle until, after having
disengaged the starter, there is a nor-
mal response from the engine when
opening the throttle.
This will enable the lubricant to reach
the correct working temperature there-
by guaranteeing a correct functioning of
all engine parts.
Avoid overheating the engine.
CR
1
2
5
4
WR
ON
3
12-07-2011 9:02:05