NORAUTO 2207763/NO6701 Instrucciones De Uso página 80

4. OPERATION
4.1 Charging
Cautions:
1. Use the original charger for charging. Unqualified chargers will shorten the life of the product and may
even be dangerous.
2. Charge the unit before using the first time.
3. After each use, press the "POWER" button (7). When the battery level of the LCD screen is 2-3 bars,
the device should be charged ASAP. If with only 1 bar, it should be charged immediately.
Charging the jump starter:
1. Wall charger: Firstly, connect the charger plug to the 220V power supply, and then connect the
charging output port to the product input port (5). At this time, the LCD screen displays the charging
status.
2. Car cigarette lighter charging: Connect the cigarette lighter output plug to the 14V 1A port (5) of the
device, and connect the cigarette lighter to the cigarette lighter port of the car for charging;
3. USB charging: Use an external USB to connect to the product's Type C port (4) for charging.
Charging Indication:
1. Charging: LCD battery level bar flashes and voltage value increases;
2. Full charged: LCD battery level bars is full and still, with "FUL" displayed the voltage is approx. 14.4V.
Note: After charging is completed, and the charger is not disconnected, the charging mode will be
automatically restored if the battery voltage drops to 12V.
NOTE: It is recommended to recharge the Jump Starter every 3-4 months to maintain the efficiency and
prolong the service life of the internal battery even if the unit has not been used.
4.2 Output 12V 10A with Cigarette Lighter
WARNING: This port is not a charging interface. It should not be connected to live equipment at
any time, nor should the output positive and negative terminals be shorted.
1. Plug one end of the equipped cigarette lighter adapter into the product's 12V 10A output.
2. Connect the 12V electronics/vehicle product to the other end of the cigarette lighter adapter cable.
3. Short press the "POWER" button (7) to start supplying power supply with 12V voltage and 10A
maximum current for the vehicle.
4.3 Jump Start
WARNING: When using this unit to start, make sure the positive and negative connections are
correct, otherwise the battery may explode.
Follow the steps below for jump start, otherwise it will be dangerous:
1. Insert "Smart Clamps" into the engine start port of the device first.
2. Connect the red (+) clamp with the positive (+) side of the battery.
3. Connect the black (-) clamp with the metal part of the engine (negative ground) or to the negative
battery.
4. After the connection is completed, follow the instructions in Table 1 below to check whether the
connection is correct and proceed to the next step.
5. Start the car and do not cranking over 5 seconds.
6. If the engine does not start successfully, check battery level and if the battery is over 3 bars, wait
3 minutes to try again.
7. After the engine is successfully started, first pull the "smart clamps" off the device and then remove
the clamps from the car battery.
8. Charge the unit immediately after each use.
78