ION TOTAL PA EXTREME Guia Del Usuario página 11

Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source, musical
instrument, or microphone. Also, try to reduce the overall volume of Total PA
using the Main Volume knob.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to
lower the bass level. This will allow you to play the music louder before clipping (distortion)
occurs.
If there is a high-pitched whistling noise when using microphones: This is probably
feedback. Point the microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume
from your source.
The Display shows "NONE": If a USB drive is already properly inserted, make sure it
contains playable files (MP3).
If you cannot connect your audio device to Total PA
•
Have your audio device (e.g., smartphone or tablet) and Total PA
together as possible while trying to connect. Make sure both the audio device and
™
Total PA Extreme are unobstructed by walls, furniture, etc.
•
Reset the Bluetooth connection on Total PA
Extreme from any other audio device and restart the search process. If this does not
work right away, power off Total PA
Pairing with a Bluetooth Device
•
Reset the Bluetooth connection on your audio device by turning Bluetooth off and
back on. You can find this under the Bluetooth menu in the Settings for your phone
or other audio device.
If this does not work, and you have connected to Total PA
™
Total PA Extreme in the list of available or previously connected devices in your
audio device's Bluetooth menu, tap the "gear" or "i" icon located next to it and then
select Unpair or Forget. Turn Total PA
again once it reappears in your available devices list.
Note: If Total PA
still within range, you may need to repeat this process with that audio device to fully
disconnect.
If you experience audio dropouts while playing music from a Bluetooth device, this
may be happening because your unit is trying to link to another speaker. This can occur if
you power off a speaker that was linked to your unit or if you have just turned on your unit
and it is in Stereo-Link mode. To stop the audio dropouts, exit Stereo-Link mode by
double-pressing the Repeat/Link button. Alternatively, you can wait for your unit to link to
another speaker if there is one within range.
If you would like to stop your speaker from automatically linking when you power it
on, make sure you double-press the Repeat/Link button to exit Stereo-Link mode before
you power it off.
for more information.
™
Extreme has been paired to another audio device recently that is
™
Extreme via Bluetooth:
™
Extreme to disconnect Total PA
™
Extreme and then power it back on. See
™
Extreme off and back on and try pairing
™
Extreme
™
Extreme as close
™
Extreme before, find
™
11