ION TOTAL PA EXTREME Guia Del Usuario página 6

11. Clip LED: The Clip LED will flash red if the signal from the input jacks or Media Panel
audio source is clipping (distortion from an overly loud signal). If this happens,
decrease the setting of the Main Volume knob or the volume for the Aux/Mic Input (if
a loud device is plugged into either).
12. Light Mode Button: Press this button to toggle between one of these modes for the
lights on the front panel:
•
Rainbow Chase Beat: Two light elements with a comet tail effect chase each
other while changing color, direction, and speed according to the tempo of the
music playing.
•
Rainbow Chase: Two light elements with a comet tail effect chase each other
slowly moving through the spectrum of colors.
•
Wheel Beat: The lights cycle through the full color spectrum in a circular motion,
changing direction and speed according to the tempo of the music playing.
•
Wheel: The lights cycle through the full color spectrum in a circular motion.
•
Dual Color Beat: The dual color lights rise and fall according to the tempo of the
music playing on the speaker.
•
Dual Color: The lights slowly glow and cycle through half the color spectrum
from top to bottom.
•
Color Beat: The lights change color and rise and fall according to the tempo of
the music playing on the speaker.
•
Color Cycle: The lights glow and slowly cycle through colors.
•
Random: Every other LED will start to flash for 3 seconds and then change
modes randomly every 6 seconds.
•
Off: The lights turn off.
Note: For the best lighting effect, you may need to adjust the volume of your device,
and/or the Source volume.
13. Power Cable Input (IEC): Insert the included power cable here to charge the unit.
14. Power Switch: Flip this switch to toggle the speaker's power on or off.
Note: Total PA
6
™
Extreme will power off after 15 minutes with no audio playing.