Specifications; Standard Equipment - RIDGID 600-I Manual

Warning
Handle
Warning
Label (115V)
Label (All)
Drive
Ring
Figure 2 – Model 690-I Power Drive
Figure 3 – 602/692 Support Arms
600-I Power Drive and 690-I Power Drive machine serial
number plate is located on the bottom of motor housing.

Specifications

Parameter
Pipe Threading Capacity
Die Head Holding
LH Threads
Support Arm
Adapter
Motor Type
Watts
Voltage/Phase Available
Amps
Operating Speed (RPM)
Controls
Gear Head
Length
Width
Height
Weight
All manuals and user guides at all-guides.com
F/R
Brush
Switch
Cap
Handle
Cord
ON/OFF
Switch
Serial Plate
Brush Cap
Motor
Fan Housing
Gear Housing
600-I Power Drive
1 / to 1 1 / inch
8 4
(3 to 32 mm)
Ring Spring
Yes
No. 602, No. 601
Not Required.
Universal Motor, Single Phase
1270 (115V), 1020 (230V)
115V/1PH, 230V/1PH
12A (115V), 5A (230V)
36 (115V), 32 (230V)
Forward/Reverse Slide Switch
ON/OFF two-step momentary contact switch
Die Cast Aluminum Permanently Greased
20 inch (508 mm)
3.75 inch (95 mm)
7.5 inch (191 mm)
12.65 lbs (5.7 kg)
600-I/690-I Power Drives
The last 4 digits of the serial number indicate the month
and year of the manufacture (MMYY).
Figure 4 – Machine Serial Number

Standard Equipment

The Model 600-I/690-I Power Drives come with the fol-
lowing items:
• Power Drive
• 690-I Adapter (690-I only)
• Operator's Manual
Selection of appropriate materials and instal-
NOTICE
lation, joining and forming methods is the responsibility of
the system designer and/or installer. Selection of improp-
er materials and methods could cause system failure.
Stainless steel and other corrosion resistant materials
can be contaminated during installation, joining and form-
ing. This contamination could cause corrosion and pre-
mature failure. Careful evaluation of materials and meth ods
for the specific service conditions, including chemical and
temperature, should be completed before any installation
is attempted.
690-I Power Drive
1 / to 2 inch
8
(3 to 50 mm)
Retaining Mechanism (1
Ring Spring ( 1
Yes
No. 692, No. 691
Used with 1 / " through 1
8
Universal Motor, Single Phase
1270 (115V), 1020 (230V)
115V/1PH, 230V/1PH
12A (115V), 5A (230V)
36 (115V), 32 (230V)
Forward/Reverse Slide Switch
ON/OFF two-step momentary contact switch
Die Cast Aluminum Permanently Greased
24.13 inch (613 mm)
4.75 inch (121 mm)
8 inch (203 mm)
21.15 lbs (9.6 kg)
1 / – 2 inch)
2
/ – 1 / inch)
1
8 4
1 / " Die Heads.
4
5