Introduction for buttons on remote controller
Note:
When selecting "
conditioner will swing up&down automatically at the maximum angle.
When selecting "
swing. Horizontal louver of air conditioner will stop at that position as shown by the
icon to swing.
6
button
● Press this button to start or stop left & right swing function. The remote controller
defaults to simple swing condition.
● Press + button and
simple swing and static swing;
● In static swing condition, pressing
changes as below:
(horizontal louvers stops
at current position)
● If the unit is turned off during swing operation,the louver will stop at present
position.
● When selecting "
air conditioner will swing left&right automatically at the maximum angle.
● When selecting "
position swing. Horizontal louver of air conditioner will stop at that position as
shown by the icon to swing.
● When selecting
air conditioner will swing circularly according to the angle as shown by the icon.
Note:
There is no this function for the units. If press this key, the main unit will
click, but it also runs under original status.
7
HEALTH SAVE button
HEALTH FUNCTION:
After pressing HEALTH button, remote controller will switch circularly as below:
"HEALTH"→"AIR"→"AIR HEALTH"→"no display"
● When selecting "HEALTH" by remote controller, HEALTH function will be started up.
● When selecting "AIR" by remote controller, AIR function will be started up.
● When selecting "AIT HEALTH", AIR and HEALTH function will be started up.
● When there's no display on remote controller, AIR and HEALTH function will be
turned off.
● AIR function is applicable for some models.
" with remote controller, it's auto swing. Horizontal louver of air
、 、
、 、
button at the same time at unit OFF to switch between
no display
(swing angle is dis-
played dynamically)
" with remote controller, it's auto swing. Horizontal louver of
、
、
、
"
(swing angle is displayed dynamically)
blinks for 2 seconds.
button, the swing angle of left & right louver
"
、
", it's the circulating swing. Horizontal louver of
55