Dc Operation For 9001 - DeVilbiss CPAP Nasal 9000 Guía De Instrucciones

10
Model 9001 also has automatic start up and automatic shut off features. To start the
blower, connect the 6 foot hose and mask, then breathe into the mask. The blower will
start after the 2nd or 3rd breath. To turn the blower OFF, remove the mask. After about
one minute of mask off, the blower will turn OFF.
Model 9001 LCD Display Window Definitions
Pressing the SELECT button changes the display to show information about the CPAP.
Press the UP or DOWN button to change the displayed setting. (The patient can only
change the Language.)
Set Pressure– CPAP pressure (cmH
•
2
Delay Time– Time for the CPAP to reach the prescription pressure after pressing the
•
Delay button.
Delay Pressure– Pressure delivered during the delay cycle.
•
Compliance Hours– Number of hours recorded while breathing was present.
•
Unit Hours– Number of hours recorded while CPAP blower was ON.
•
Firmware Version– Identification for firmware installed in the CPAP.
•
Serial Number– Serial number of the CPAP unit, same as on the label.
•
Language– Language selected for LCD display messages.
•
• Off- Blower is OFF AC or DC power is connected.
• Error- An error has been detected by the firmware, the CPAP is in a fail safe mode.
A-900
All manuals and user guides at all-guides.com
O p e r a t i o n
0) prescribed by your doctor
O p e r a t i o n
DC Operation of the 9001
The DeVilbiss CPAP Model 9001 can be operated from a 12V DC power source in a
motor home, recreational vehicle or boat. Connect the DeVilbiss CPAP to a 12V
cigarette lighter in a vehicle with a negative ground using DeVilbiss adapter plug part
#7304D-619. There are no switches or fuses to change for DC operation. Do not use
the CPAP in a moving vehicle.
CAUTION– If this device is used with a 12VDC power source, loss of power will result in
loss of CPAP therapy; there is no internal battery. If the 12VDC power supply is
an automobile or truck battery, the battery should be professionally tested to
make sure the battery is properly charged. A weak battery can result in
insufficient voltage to operate the CPAP and loss of CPAP therapy. Do not
operate the unit while the vehicle is running.
CAUTION– Use only DeVilbiss DC power cord part #7304D-619. Use of any other cord
may cause damage to the CPAP or the vehicle electrical system.
CAUTION– The CPAP will operate for 8 hours on a car battery. The battery should be
professionally tested before using the CPAP overnight to make sure that the
battery is in good condition and is fully charged.
DC Power Cord 7304D-619
12 Volt DC jack
11
Plug in to car cigarette lighter
A-900