Technical Information; I Nsta Ll At I O N Co N Sid E R Ati Ons - Hansgrohe AXOR Urquiola 11034 1 Serie Instrucciones De Montaje / Manejo / Garantía

T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
lavatory
bidet
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.

I NSTA LL AT I O N CO N SID E R ATI ONS

⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ The drain is intended for use in a sink with an overflow.
If your sink does not have an overflow, or if this drain
is too small for the hole in your sink, please refer to the
instructions included with the sink. Some sinks include
special drain installation instructions and/or parts.
Others require the use of a specialty drain. Hansgrohe
is not respnsible for the cost of a specialty drain.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
2.2 GPM (8.3 L/min)
1⅜" (35 mm)
1⅝" (40 mm)
E N G L I S H
⁄ 11034XX1, 11035XX1: This faucet does not include
a drain or a pull rod.
⁄ The hot and cold supply hoses included with this
faucet are for use with ⅜ stops. If your stops are
a different size, install new stops. Adapters are not
available from Hansgrohe.
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a
safe place. The receipt is required should it be neces-
sary to request warranty parts.